16 12 2013 EIGERFLEX CPE Subject to technical changes 3 520 Connection and end Frost protection strip 1 Technical data Frost protection strip Max heating circuit length based on switch on temperature of 10 C 16 A max 100 m 10 A max 60 m Regulation Thermostat UTR15 Adjustment range 5 C to 15 C pipe contact thermostat 2 Preparation Remove 35 40 cm of insulation at the ends and carefully expose the strip Then shorten the inner pipe to length according to the fitting instructions 35 40 cm Shorten as described in fitting instructions Electrical installation according to local regulations Only to be connected by an authorised electrical installer 30 mA residual current operated device FI required by regulations Automatic fuse C characteristic 4 Installing the temperature sensor on the pipe The temperature sensor has to be installed on the medium pipe opposite the heating strip It must be fitted at the coldest point on the pipe outside the building For this purpose cut open a 10x7 cm area of the outer casing and peel back cut out 10x7cm foam and fix the temperature sensor on the inner pipe with adhesive tape Fill the hole with the insulating material that is provided apply filling adhesive S1113 below and above the temperature sensor cable see sketch seal with shrinkdown tube Protect the heating strip against moisture Connection box provided by the customer Connection Heating strip cold lead max 100 m Temperature sensor on pipe End closure Frost protection strip Thermostat UTR 15 with temperature sensor Sensor cable length 3 m can be extended to a max of 100 m with screened cable 1 5 mm 230 V EIGERFLEX Temperature sensor cable Shrinkdown tube Filling adhesive S1113 80 mm long Shrinkdown tube Temperature sensor ca 7 c m ca 10 cm EIGERFLEX EIGERFLEX EIGERFLEX 3 Installation procedure

Hinweis: Dies ist eine maschinenlesbare No-Flash Ansicht.
Klicken Sie hier um zur Online-Version zu gelangen.